Southern California Club Xterra

Southern California Club Xterra => SCCX General Discussion => Topic started by: Spectre on February 26, 2016, 06:10:03 PM

Title: Coax question
Post by: Spectre on February 26, 2016, 06:10:03 PM
Hey guys. What brand/type of coax are you using for your hams?   Are you guys just using RG-58 and not worried about any signal/power loss since the runs are under 20' ?
Title: Re: Coax question
Post by: GreenGoon on February 26, 2016, 07:30:59 PM
That's what I use.
Title: Re: Coax question
Post by: Spectre on February 26, 2016, 08:39:03 PM
I want to install my sirus antenna but I don't want to go through pulling everything apart multiple times.. I need to find a place locally that carries that coax and I'll just run it now and put ends on it later when I get the Antenna mounts and antennas put on.
Title: Re: Coax question
Post by: Celt on February 26, 2016, 09:06:00 PM
I've had great service from these guys. They might not have a location super close but it's a place to start.


                  http://www.hamradio.com/
Title: Re: Coax question
Post by: Spectre on February 27, 2016, 07:22:18 AM
I've had great service from these guys. They might not have a location super close but it's a place to start.


                  http://www.hamradio.com/

HRO is a good place..  Sucks it's 1 1/2 hours from me. Though I don't know if I'll be doing any of that stuff this weekend so I may just order the cable over the internet.  I've read that 18' is pretty sufficient, so if I up it and get a 50' roll and run it I'll have plenty of extra. I don't know when I'll have the antenna mount so I will just have to have the coax ran and tucked away uintil I'm ready.
Title: Re: Coax question
Post by: Ghost65 on February 27, 2016, 09:26:35 AM
Check out AES ham on the internets...Google Amateur Electronic Supply.

Their Las Vegas location ships quickly, and in California you usually get your stuff in 2-3 days.

Linky:  AES (http://www.aesham.com/)
Title: Re: Coax question
Post by: Celt on February 27, 2016, 10:06:09 AM
HRO is a good place..  Sucks it's 1 1/2 hours from me. Though I don't know if I'll be doing any of that stuff this weekend so I may just order the cable over the internet.  I've read that 18' is pretty sufficient, so if I up it and get a 50' roll and run it I'll have plenty of extra. I don't know when I'll have the antenna mount so I will just have to have the coax ran and tucked away uintil I'm ready.

 You should be able to get your coax in 25' rolls so you don't have all that extra sitting around. Take the time to measure out correctly how much you will need so you don't come up too short or have a bunch extra just sitting around wasting your money.
Title: Re: Coax question
Post by: GreenGoon on February 27, 2016, 04:20:20 PM
I second John on AES Las Vegas. The regular priced shipping usually gets to me overnight.
Title: Re: Coax question
Post by: Spectre on February 28, 2016, 12:30:34 PM
My sister recently sold her house that was 1 mile from Anaheim's HRO has to run over there today to pick up some stuff that was delivered there by mistake instead of here said she'd stop by HRO for me..  If she isn't able to  then I'll go through the AES route.

As for having a little extra coax laying around, I don't mind. I can make little patch cables to go between my turner and other radios.
Title: Re: Coax question
Post by: JFanaselle on February 28, 2016, 02:53:34 PM
I'm pretty sure all of HRO's stores are closed on Sundays. :( Sorry for the bad news. I drove all the way down to the San Diego location once and learned that the hard way.
Title: Re: Coax question
Post by: Spectre on February 28, 2016, 04:39:01 PM
I'm pretty sure all of HRO's stores are closed on Sundays. :( Sorry for the bad news. I drove all the way down to the San Diego location once and learned that the hard way.

My sister sent me a picture of the store being closed. Guess it's AES for me. =)   I need my hardbody to sell so I can buy some other stuff I want for the Xterra.  =)
Title: Re: Coax question
Post by: JFanaselle on February 29, 2016, 10:07:43 AM
Let me know if you need any last minute supplies (I think I saw in the other thread that you already placed your order through AES). I'm going to hit up the San Diego (Clairemont) HRO location on my lunch break today to pick up a new FT-60R handheld. I dropped my old one and toasted the audio output circuit. I'd be happy to pick something up for you if you need. I live in Murrieta, so the drive from Hemet is not bad and I'm usually in Hemet once or twice a week anyway because my parents live there.
Title: Re: Coax question
Post by: Spectre on February 29, 2016, 10:50:05 AM
I know I'll need some pl-259 connectors.  I think 4. That and I'll need someone with an swr meeter to help me tune it.  I couldn't find one on aes. Though I didn't look super hard.  The order was expensive enough. :( I still need to buy a fire stick antenna as well

Sent from my SAMSUNG-SM-N910A using Tapatalk

Title: Re: Coax question
Post by: JFanaselle on February 29, 2016, 11:24:10 AM
Looks like my lunch-time trip is actually going to have to wait until another day. Just had some urgent mid-day meetings pop up.  >:(

I'll hit you up again if I'm planning to make the trip sometime this week. Sorry about that.
Title: Re: Coax question
Post by: Spectre on February 29, 2016, 11:51:13 AM
Don't be sorry. I know how work can ruin fun time.  Lol.  I'm in no super rush. The weather is getting better so I'll be commuting on thr bike mainly.  The Xterra can sit and collect dust.  :)

Sent from my SAMSUNG-SM-N910A using Tapatalk

Title: Re: Coax question
Post by: Spectre on March 01, 2016, 06:40:59 PM
I think i made a mistake.  I should of got RG-8 cable not RG-58. 58 seems way to small.   


*edit* 
I'm trying to do some research.. It seems a few people run RG-58 and say the power loss is negligible on the 10 - 15 foot runs. that I'll need.   Damnit I wish I would of remembered all the stuff I studied  to get my license.

*edit* again
disregard.  I'll keep the 58 and just need to get the connectors now.  I got all worried for no reason.. lame.

heh

Title: Re: Coax question
Post by: knightrider on March 01, 2016, 10:45:13 PM
Heck I have 6 ft of rg-316 and have never had a problem, with how short the run is, difference in loss is negligible

Sent from my rooftop tent while stargazing